HP 3000 Manuals HP 3000 Manuals
System Startup Procedure The following procedure is an example of what to enter and what it looks like to start a system. To initiate the startup process enter: CTRLB [REV BEG]
NOTE If you have a 99X system, you must transfer to the service processor before you reset the system. _______________________________________ | | | | | CM> SP | | | _______________________________________ If you have a 9X8LX or 9X8RX system, a PDC screen is displayed. Type BO to boot from the primary path.
[REV END] _________________________________________________________________ | | | | | CM> TC | | | | Processor Dependent Code (PDC) revision 3.2 | | | | Console path = 2/4.1.0.0.0.0.0 | | Primary boot path = 2/4.0.0.0.0.0.0 | | Alternate boot path = 6/4.3.0.0.0.0.0 | | | | Boot from primary boot path (Y or N)?> y | | | | Interact with IPL (Y or N)?> Y | | | | NMSAVE Version 2.2 | | DUMPAREA found, save main memory to disc | | ISL loaded | | | | ISL Revision A.00.28 July 15, 1993 | | | | Cannot find an auto-execute file. AUTOBOOT ABORTED. | | | | ISL>start recovery | | Initialize_genesis - Version : <<870204.1552>> | | THU, APR 27, 1989, 2:23:36PM (y/n)? y | | : | | | _________________________________________________________________ Example 2-11. System Startup Procedure
NOTE Currently there is no autoexecute file available; therefore, you must ignore the statement Cannot find an auto-execute file. AUTOBOOT ABORTED. This does not present any problems; just continue with the START commnand in ISL.
For further information about system startups, refer to Chapter 3 .