HP 3000 Manuals HP 3000 Manuals
Chapter 40 CIPER Devices
(CIPER)
--------------------------------------------------------------
---------------------------------------------------------------
1 MESSAGE Ldev #\ not ready; check cable connections.
(CIPER 1)
---------------------------------------------------------------
2 MESSAGE Ldev #\ has been powered up or reset. (CIPER 2)
---------------------------------------------------------------
3 MESSAGE Ldev #\ has been placed off-line. (CIPER 3)
---------------------------------------------------------------
4 MESSAGE Ldev #\ has been placed on-line. (CIPER 4)
---------------------------------------------------------------
5 MESSAGE Ldev #\ reports out of paper; please check and
correct if necessary. (CIPER 5)
---------------------------------------------------------------
6 MESSAGE Ldev #\ reports paper jam; please check and
correct if necessary. (CIPER 6)
---------------------------------------------------------------
7 MESSAGE Ldev #\ reports platen open; please check and
correct if necessary. (CIPER 7)
---------------------------------------------------------------
8 MESSAGE Ldev #\ reports ribbon error; please check and
correct if necessary. (CIPER 8)
---------------------------------------------------------------
9 MESSAGE Ldev #\ experienced self-test failure. Failure
code = !. (CIPER 9)
---------------------------------------------------------------
10 MESSAGE Ldev #\ reports protocol error: illegal header
length received. (CIPER 10)
---------------------------------------------------------------
11 MESSAGE Ldev #\ reports protocol error: record sequence
error in record received. (CIPER 11)
---------------------------------------------------------------
12 MESSAGE Ldev #\ reports protocol error: incorrect
creator of record received. (CIPER 12)
---------------------------------------------------------------
13 MESSAGE Ldev #\ reports protocol error: undefined
command received. (CIPER 13)
---------------------------------------------------------------
14 MESSAGE Ldev #\ reports protocol error: undefined data
type received. (CIPER 14)
---------------------------------------------------------------
15 MESSAGE Ldev #\ reports protocol error: illegal format
number in environmental status block. (CIPER 15)
---------------------------------------------------------------
17 MESSAGE Ldev #\ reports protocol error: illegal block
label length received. (CIPER 17)
---------------------------------------------------------------
18 MESSAGE Ldev #\ reports protocol error: transport
service error. (CIPER 18)
---------------------------------------------------------------
19 MESSAGE Ldev #\ reports protocol error: data overrun
from host. (CIPER 19)
---------------------------------------------------------------
20 MESSAGE Ldev #\ reports data loss. (CIPER 20)
---------------------------------------------------------------
30 MESSAGE CIPER ldev #\ is being shut down due to an
internal data integrity error. Access to device
will be denied until a WARMSTART is performed.
(CIPER 30)
---------------------------------------------------------------