HP 3000 Manuals

Ch 68. Secondary Storage Management [ MPE/iX Error Messages Manual Volume III ] MPE/iX 5.0 Documentation


MPE/iX Error Messages Manual Volume III

Chapter 68  Secondary Storage Management 

(Subsystem 145) 

--------------------------------------------------------------

---------------------------------------------------------------

1            MESSAGE    Disk space is not available.

           CAUSE      Same as message content.

           ACTION     Purge old files or install a new disk.

---------------------------------------------------------------

2            MESSAGE    Allocation was disabled on this device.

           CAUSE      Same as message content.

           ACTION     Enable allocation on this device.

---------------------------------------------------------------

3            MESSAGE    SECONDARY STORAGE MAP (page allocation) is out of
                      sync.

           CAUSE      Same as message content.

           ACTION     Take a system memory dump for debugging purposes.

---------------------------------------------------------------

4            MESSAGE    Bad device identification was supplied by caller.

           CAUSE      Same as message content.

           ACTION     None.

---------------------------------------------------------------

5            MESSAGE    Invalid unit parameter was supplied by caller.

           CAUSE      Same as message content.

           ACTION     None.

---------------------------------------------------------------

6            MESSAGE    Invalid space limit was detected.

           CAUSE      Same as message content.

           ACTION     None.

---------------------------------------------------------------

7            MESSAGE    Invalid SECONDARY STORAGE MAP version was
                      detected.

           CAUSE      Inconsistent version of the operating system.

           ACTION     Reinstall the operating system.

---------------------------------------------------------------

8            MESSAGE    SECONDARY STORAGE MAP is not on the page
                      boundary.

           CAUSE      Same as message content.

           ACTION     Take a system memory dump for debugging purposes.

---------------------------------------------------------------



MPE/iX 5.0 Documentation