HP 3000 Manuals

(Subsystem 98) (contd) [ MPE/iX Error Messages Manual Volume II ] MPE/iX 5.0 Documentation


MPE/iX Error Messages Manual Volume II

(Subsystem 98) (contd) 

1321         MESSAGE    The current process had no standard signal port.

           CAUSE      GET_TIMEREQ: get_global_port_num returned no number
                      for the standard signal port.

---------------------------------------------------------------

1322         MESSAGE    An invalid code was received from compatibility
                      TIMEREQ.

           CAUSE      GET_TIMEREQ: invalid timer code parameter received.

---------------------------------------------------------------

1323         MESSAGE    Bad TABLE MANAGEMENT status was received when the
                      timer entry was released.

---------------------------------------------------------------

1324         MESSAGE    The current process had no standard signal port.

           CAUSE      PROC_PAUSE: get_global_port_num returned no number
                      for the standard signal port.

---------------------------------------------------------------

1325         MESSAGE    The procedure INITIALIZE_TIMERS failed to create
                      TIMER ENTRY TABLE.

           CAUSE      The call to create_table failed.

---------------------------------------------------------------

1326         MESSAGE    The procedure INITIALIZE_TIMERS failed to create
                      TIMER global area.

           CAUSE      The call to create_object failed.

---------------------------------------------------------------

1327         MESSAGE    PDC TOD read failed.

           CAUSE      PDC_TIME: call to get_pdc_tod failed.

---------------------------------------------------------------

1328         MESSAGE    PDC TOD write failed.

           CAUSE      SET_PDC_TIME: call to pdc_access_4 failed.

---------------------------------------------------------------

1329         MESSAGE    Can not read PDC TOD calib.

           CAUSE      PDC_TIMER_CAL: call to get_pdc_timer failed.

---------------------------------------------------------------

1330         MESSAGE    Can not read PDC TOD calib.

           CAUSE      PDC_TIMER_ACC: call to get_pdc_timer failed.

---------------------------------------------------------------

1331         MESSAGE    CLOCK_SYNC WRITE failed.

           CAUSE      SYBC_CLOCKS: call to set_pdc_timer failed.

---------------------------------------------------------------

1332         MESSAGE    The procedure failed to create port for clock
                      sync.

           CAUSE      INIT_HARDWARE_CLOCK_UPDATES: call to create_port
                      failed.

---------------------------------------------------------------

 1333        MESSAGE    The procedure failed to get TIMER for clock sync.

           CAUSE      INIT_HARDWARE_CLOCK_UPDATES: call to get_timer
                      failed.

---------------------------------------------------------------

1334         MESSAGE    Clock failed to notify a port of a clock
                      interrupt.

           CAUSE      TIMER_INTERRUPT HANDLER: call to send_msg failed
                      and the system was not in the shutdown state.

---------------------------------------------------------------

1335         MESSAGE    An attempt was made to release timer entry zero.

           CAUSE      RELEASE_TIMER: timer entry zero was received as an
                      input parameter.

---------------------------------------------------------------

1340         MESSAGE    A high priority machine check occurred.

---------------------------------------------------------------

1341         MESSAGE    A low priority machine check occurred.

---------------------------------------------------------------

1342         MESSAGE    ILLEGAL INSTRUCTION TRAP occurred while on the
                      INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1343         MESSAGE    ILLEGAL INSTRUCTION TRAP occurred while on the
                      INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1344         MESSAGE    A BREAK instruction occurred on the INTERRUPT
                      CONTROL STACK (ICS).

---------------------------------------------------------------

1345         MESSAGE    PRIVILEGED OPERATION TRAP occurred while on the
                      INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1346         MESSAGE    PRIVILEGED REGISTER TRAP occurred while on the
                      INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1347         MESSAGE    OVERFLOW TRAP occurred while on the INTERRUPT
                      CONTROL STACK (ICS).

---------------------------------------------------------------

1348         MESSAGE    CONDITIONAL TRAP occurred while on the INTERRUPT
                      CONTROL STACK (ICS).

---------------------------------------------------------------

1349         MESSAGE    ASSIST EXCEPTION TRAP occurred while on the
                      INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1350         MESSAGE    DATA MEMORY PROTECTION TRAP occurred while on the
                      INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1351         MESSAGE    CM STACK OVERFLOW procedure occurred while
                      DISABLED OR PDISABLED.

---------------------------------------------------------------

1352         MESSAGE    CM STACK OVERFLOW occurred while handling CM
                      STACK OVERFLOW.

---------------------------------------------------------------

1353         MESSAGE    CM STACK OVERFLOW failed to change break range.

---------------------------------------------------------------

1355         MESSAGE    ASSIST EMULATION TRAP occurred while on the
                      INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1356         MESSAGE    HIGH PRIVILEGE TRANSFER TRAP occurred while on
                      the INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1357         MESSAGE    LOW PRIVILEGE TRANSFER TRAP occurred while on the
                      INTERRUPT CONTROL STACK (ICS).

---------------------------------------------------------------

1358         MESSAGE    TAKEN BRANCH TRAP occurred while on the INTERRUPT
                      CONTROL STACK (ICS).

---------------------------------------------------------------

1360         MESSAGE    CREATE_TABLE failed.

           CAUSE      CREATE_MIB: bad status from create_table.

---------------------------------------------------------------

1361         MESSAGE    One or more parameters are bad.

           ACTION     Check for correct options before calling
                      get_short_int_entry.

---------------------------------------------------------------

1362         MESSAGE    Bad MIB address.

           ACTION     Check that mib_state is allocated_mib before
                      calling rel_short_int_entry.

---------------------------------------------------------------

1365         MESSAGE    Bad status returned for GET_TABLE entry.

---------------------------------------------------------------

1366         MESSAGE    Bad status returned from FAST_RELEASE_TABLE_ENTRY.

           CAUSE      REL_SHORT_INT_ENTRY: bad status from
                      tbl_fast_release_table_entry.

---------------------------------------------------------------

1367         MESSAGE    Bad status returned from FAST_RELEASE_TABLE
                      ENTRY.

           CAUSE      REL_LONG_INT_ENTRY: bad status from
                      release_table_entry.

---------------------------------------------------------------

1380         MESSAGE    External interrupt handler failed to initialize
                      its EXTERNAL INTERRUPT TABLE (EXT_INT_TABLE).

           CAUSE      There is a problem with VSM in CREATE_OBJECT
                      interface.

---------------------------------------------------------------

1401         MESSAGE    Can not send interrupt message to the system.

           CAUSE      SEND MESSAGE failure.

---------------------------------------------------------------

1410         MESSAGE    Could not create the system logging globals area.

           CAUSE      LOG process could not successfully create the
                      system logging global object.

---------------------------------------------------------------

1411         MESSAGE    The procedure could not get standard message port
                      for the system logging process.

           CAUSE      LOG process could not get standard message port.

---------------------------------------------------------------

1412         MESSAGE    The current system log file and its label are
                      inconsistent.

           CAUSE      When LOG process tries to post a block to the
                      current system log file, it finds that the log file
                      is not consistent with its label.

---------------------------------------------------------------

1421         MESSAGE    Internal table pool resource is corrupted.

---------------------------------------------------------------

1422         MESSAGE    Internal table entry link is corrupted in the
                      procedure REL_LONG_MIB_ENTRY.

---------------------------------------------------------------

1423         MESSAGE    Internal table entry link is corrupted in the
                      procedure REL_SHORT_MIB_ENTRY.

---------------------------------------------------------------

1451         MESSAGE    A process is executing the procedure PM_CLEANUP
                      other than the process MANAGEMENT CLEANUP process.

---------------------------------------------------------------

1452         MESSAGE    After the system has completed its boot up, an
                      attempt to make selected system process stacks
                      swappable failed.

---------------------------------------------------------------

1453         MESSAGE    After the system has completed its boot up, an
                      attempt to lock the system processes stacks in the
                      VPN cache failed.

---------------------------------------------------------------

1454         MESSAGE    During system boot, an attempt to create the
                      CLEANUP process failed.

---------------------------------------------------------------

1455         MESSAGE    A process holding a SIR has been terminated.

---------------------------------------------------------------

1456         MESSAGE    The trap handling procedure encountered a trap
                      while processing a trap.

---------------------------------------------------------------

1457         MESSAGE    A system process is being terminated due to a
                      trap.

---------------------------------------------------------------

1458         MESSAGE    A critical process is being terminated due to a
                      trap.

---------------------------------------------------------------

1459         MESSAGE    A trap occurred on a process whose state is not
                      ALIVE.

---------------------------------------------------------------

1460         MESSAGE    We are terminating a process whose state is not
                      ALIVE.

---------------------------------------------------------------

1461         MESSAGE    We continued to execute in TERMINATE_PROCESS
                      after giving up the CPU.

---------------------------------------------------------------

1462         MESSAGE    While the system is booting, we were unable to
                      obtain a pointer to the PCB TABLE (CONVERT_DST).

---------------------------------------------------------------

1463         MESSAGE    While the system was booting, we were unable to
                      initialize the port for the BOOT process
                      (SETUP_PORTS).

---------------------------------------------------------------

1464         MESSAGE    While the system was booting, a release object
                      failed on the temporary PIB for the BOOT process
                      (RELEASE_OBJECT).

---------------------------------------------------------------

1465         MESSAGE    While the system was booting, we were unable to
                      allocate a process ID for the BOOT process
                      (ALLOCATE_PID).

---------------------------------------------------------------



MPE/iX 5.0 Documentation