HP 3000 Manuals HP 3000 Manuals
Resume Printing with the SPOOLER
To resume printing after the spooler has been suspended, use the SPOOLER
DEV=;RESUME command. If only the ldev parameter is specified, printing
resumes at the beginning of the spoolfile, for either this device or the
device class which contains the device, with the highest print priority.
If any other parameter is included, the spooler tries to resume printing
the previously ACTIVE file. It will do so even if:
* The file is not the highest priority file available or has a priority
below the outfence.
* It has been assigned to another device or class while the spooler is
suspended.
However, the attempt will fail (and the spooler will select the highest
priority available file) for the following reasons:
* The file is not available because it became ACTIVE on another device
while this spooler process was suspended.
* The file was deleted while the spooler was suspended.
Resume Spooling
To resume spooling from the beginning of the spoolfile on logical device
number 6, enter:
SPOOLER DEV=6;RESUME;OFFSET=1 Return
The system displays:
_________________________________________________________________
| |
| |
| 14:35/32/SP#6/SPOOLER RESUMED |
| |
_________________________________________________________________
To suspend and then resume spooling on logical device number 6,
backspacing 5 pages, enter:
SPOOLER DEV=6;SUSPEND;KEEP Return
SPOOLER DEV=6;RESUME;OFFSET=-5 Return