HP 3000 Manuals HP 3000 Manuals
System Debug Command Specifications System Debug tools share the same command set. A few commands, however, are inappropriate in either DAT or Debug. These commands are clearly identified as "DAT only" or "Debug only" on the top of the page that defines the command. Debug only The following Debug commands cannot be used in DAT: B All forms of the break command BD Breakpoint delete BL Breakpoint list C[ONTINUE] Continue DATAB Data breakpoint DATABD Data breakpoint delete DATABL Data breakpoint list F All forms of the FREEZE command FINDPROC Dynamically loads NL library procedure KILL Kills a process LOADINFO Displays currently loaded program / libraries LOADPROC Dynamically loads CM library procedure M All forms of the modify command S[S] Single step TERM Terminal semaphore control TRAP Arm/Disarm/List Traps UF All forms of the UNFREEZE command DAT only The following DAT commands cannot be used in Debug: CLOSEDUMP Closes a dump file DEBUG Enters Debug; used to debug DAT DPIB Displays a portion of the Process Information Block DPTREE Displays the process tree DUMPINFO Displays dump file information GETDUMP Reads in a dump tape to create a dump file OPENDUMP Opens a dump file PURGEDUMP Purges a dump file