HP 3000 Manuals HP 3000 Manuals
Driver/Validator Messages (5600-5624)
--------------------------------------------------------------------------------------
5600 MESSAGE Exceeded maximum number of allowed errors (SDWARN 5600)
CAUSE The program encountered the number of errors specified as the
maximum in the PARM option.
ACTION Correct the error(s) found and either rerun or finish running
the job.
--------------------------------------------------------------------------------------
5601 MESSAGE Logging has been disabled (SDWARN 5601)
CAUSE Logging has been disabled to prevent SDUTIL from overwriting an
existing log file.
ACTION If you do nothing, nothing will be logged. You can, instead,
exit the program and specify a new file or a file that can be
overwritten as the log file.
CAUSE Logging has been disabled because the current log file has
filled up and an alternate log file is not available.
ACTION If you do nothing, nothing will be logged. You can, instead,
exit the program and specify a new file or a file that can be
overwritten as the log file.
CAUSE Logging has been disabled because SDUTIL is unable to write to
the log file.
ACTION If you do nothing, nothing will be logged. You can, instead,
exit the program, refer to the associated file error and correct
the indicated problem.
--------------------------------------------------------------------------------------
5602 MESSAGE Logging proceeding onto a temporary log file (SDWARN 5602)
CAUSE The permanent log file has been filled up. Logging has been
redirected to a temporary log file with the same name as the
permanent log file.
ACTION No action is necessary.
--------------------------------------------------------------------------------------
5603 MESSAGE SDLOG is a temporary file. Save if needed (SDWARN 5603)
CAUSE The log file was saved as a temporary file.
ACTION If the log file is not needed, no action is necessary. It will
remain a temporary file. If the log file is needed, save it.
--------------------------------------------------------------------------------------
5604 MESSAGE Expected End-Of-File NOT found in input file (SDERR 5604)
CAUSE Unexpected input lines found in the input file after an EXIT
command.
ACTION Remove the lines after the EXIT command or move the EXIT command
to the end of the file.
--------------------------------------------------------------------------------------
(cont.)
--------------------------------------------------------------------------------------
5605 MESSAGE Hit End-Of-File of input file before executed an EXIT (SDERR
5605)
CAUSE SDUTIL has reached the end of the input file without finding an
EXIT command.
ACTION Place an EXIT command at the end of the input file.
--------------------------------------------------------------------------------------
5606 MESSAGE Invalid command (SDERR 5606)
CAUSE The command entered is not recognized by the program.
ACTION Issue a command that is recognized by the program. Use HELP for
a list of valid commands.
--------------------------------------------------------------------------------------
5607 MESSAGE Command not valid when the dictionary is not open (SDERR 5607)
CAUSE The command entered is not allowed before the dictionary is
opened.
ACTION Issue a command that is valid before the dictionary is opened or
open the dictionary and then issue the command.
--------------------------------------------------------------------------------------
5608 MESSAGE Command generation has been disabled (SDWARN 5608)
CAUSE The command file SDMCOM cannot be opened or overwritten, so
command generation has been disabled.
ACTION If you want command generation, rerun SDUTIL with a good SDMCOM
file. No action is necessary if you do not want command
generation.
--------------------------------------------------------------------------------------