HP 3000 Manuals HP 3000 Manuals
Job Control Word (JCW) The Job Control Word (JCW) is a system parameter which indicates the termination condition of the SDINIT program. Upon exiting from SDINIT, the JCW will be set to one of two values: _________________________________________________________________ | | | 0 Program terminated normally | | | | 32768 Program terminated abnormally (FATAL JCW value)| _________________________________________________________________ The JCW allows the batch mode user to test for the termination condition and act accordingly. Information on job control words is located in the MPE V Commands Reference Manual (32033-90006). More information on the JCW, and a sample batch job is located in Chapter 2 of the HP System Dictionary/XL SDMAIN Reference Manual (32254-90001).