HP 3000 Manuals HP 3000 Manuals
SDGetDomainList
Retrieves all domains in the dictionary .
Syntax
SDGetDomainList (Dcb,RetrievalID,Domain,Status)
Parameters
Dcb Required input; type = DcbType
This parameter passes information about the
dictionary to this intrinsic. It is
initialized by the SDOpen intrinsic.
RetrievalID Required input; Output; type = RetrievalIDType
This parameter is used internally to pass
information between multiple calls of this
intrinsic, to retrieve all of the domains in
the dictionary.
To find the first domain, initialize the first
four bytes of this parameter to a binary zero.
To find additional domains, call this intrinsic
once for each domain to be returned.
Domain Output; type = NameType
This parameter returns the name of a domain for
each successful call of the intrinsic.
Status Output; type = StatusType
This parameter contains information indicating
the success or failure of the intrinsic call.
This information is detailed in Table Table
3-1, located in Chapter 3 of this manual.
If this intrinsic is successful, the Status
parameter contains the following information,
in addition to the description contained in
Table Table 3-1.
----------------------------------------------------------------------
| | |
| Bytes | Contain |
| | |
----------------------------------------------------------------------
| | |
| 17 - 20 | Internal domain number |
| | |
----------------------------------------------------------------------
Discussion
The following restrictions apply when using this intrinsic:
1. Open mode--The dictionary must be opened in Shared Read mode,
Shared Read-Only mode, Shared Update mode, or Exclusive Update
mode.
2. Security--The current scope must be either the Dictionary
Administrator scope or a scope with Domain capability.
3. The common domain is not included in the list of domains returned
by this intrinsic.