HP 3000 Manuals HP 3000 Manuals
Define Messages (1325-1349)
1325 MESSAGE The ! keyword is ignored in customization mode (SDWARN 1325)
CAUSE The indicated keyword is not allowed if the open mode of the
dictionary is going to be CUSTOMIZATION.
ACTION Do nothing as the clause is ignored. The next time the
dictionary is open in CUSTOMIZATION mode, do not specify this
keyword.
--------------------------------------------------------------------------------------
1326 MESSAGE Both VERSION and STATUS were specified. STATUS is ignored
(SDWARN 1326)
CAUSE Both the VERSION and STATUS keyword cannot be specified in the
same command. Either VERSION for a specific version or STATUS
for the last version of the given status should be used.
ACTION Do nothing as the version will be used and the status ignored.
The next time the dictionary is opened, specify either a
specific version (VERSION) or a specific status (STATUS) but not
both.
--------------------------------------------------------------------------------------
1327 MESSAGE Quoted passwords cannot extend to multiple lines (SDERR 1327)
CAUSE If the password is entered within quotes it must be entered on a
single line.
ACTION Specify the password so that the opening and closing quotes are
on the same line.
--------------------------------------------------------------------------------------
1328 MESSAGE Invalid scope password. Remember case counts (SDWARN 1328)
CAUSE An invalid password has been entered in response to the scope
password prompt. Remember, System Dictionary distinguishes
between uppercase and lowercase characters in a scope password.
ACTION Specify the correct password for the scope.
--------------------------------------------------------------------------------------
1329 MESSAGE Exceeded maximum tries for a valid scope password (SDERR 1329)
CAUSE Unable to open the dictionary because a valid scope password was
not specified within three tries.
ACTION Reenter the DEFINE command and specify the correct password for
the scope.
--------------------------------------------------------------------------------------
1330 MESSAGE Unexpected End-Of-File on $STDINX (SDERR 1330)
CAUSE Reached the end of the file on $STDINX when trying to read the
scope password.
ACTION Refer to the associated file error and correct the indicated
problem.
--------------------------------------------------------------------------------------
1331 MESSAGE Unable to turn the echo facility off (SDERR 1331)
CAUSE Unable to turn the echo facility off through the FControl
Intrinsic when prompting for the scope password.
ACTION Contact the DA. (Remember to get the associated file error,
too.)
--------------------------------------------------------------------------------------
1332 MESSAGE Unable to turn the echo facility on (SDERR 1332)
CAUSE Unable to turn the echo facility on through the FControl
Intrinsic when prompting for the scope password.
ACTION Contact the DA. (Remember to get the associated file error,
too.)