HP 3000 Manuals

HP Transact Reference Manual

USE 

Reads TRANDEBUG commands from the specified MPE/iX file.

Syntax 

USE filename 

Parameters 

filename         The MPE/iX filename to use as input to TRANDEBUG.

Discussion 

This command allows you to use an MPE/iX file as input to TRANDEBUG. You
can either create this file using an editor or you can use the LOG
command.  Each line in the file is treated as one TRANDEBUG command and
execution of this file continues until the EOF is reached or an error
occurs.

Example 

The following example shows how the USE command works.

     TRANDEBUG> :print logfile1 
     break set 24,,,,{DISPLAY MATCH;STEP}
     break set 28,1
     break list
     LOG CLOSE
     TRANDEBUG> USE logfile1 
     TRANDEBUG> break set 24,,,,{DISPLAY MATCH;STEP} 

                   BREAKPOINT SET:

                     SYSTEM  SEGMENT   OFFSET   COUNT          COMMAND LIST
                     ------------------------------------------------------
                 1. TEST          0       24       1  DISPLAY MATCH;STEP

     TRANDEBUG> break set 28,1 

                   BREAKPOINT SET:

                     SYSTEM  SEGMENT   OFFSET   COUNT          COMMAND LIST
                     ------------------------------------------------------
                 2. TEST          1       28       1

     TRANDEBUG> break list 

                CURRENT BREAKPOINTS:

                SYSTEM  SEGMENT   OFFSET   COUNT          COMMAND LIST
                ------------------------------------------------------
            1. TEST          0       24       1  DISPLAY MATCH;STEP
            2. TEST          1       28       1

     TRANDEBUG> LOG CLOSE 
     TRANDEBUG> :print logfile1  
     break set 24,,,,{DISPLAY MATCH;STEP}
     break set 28,1
     break list
     LOG CLOSE

MPE/iX 5.0 Documentation