HP 3000 Manuals

Getting Started With TRANSACT V

Chapter 7  Using Transact Without a Dictionary 

Transact can be used with either Dictionary/3000 or System Dictionary.
It can also be used without a dictionary and can still interface with
IMAGE, MPE, KSAM, and VPLUS.

This section uses examples from previous sections, modifying them so that
they work independent of the dictionary.  All that has to be done is to
replace the common data definitions in the dictionary with program data
definitions.  These examples are shown below with the changes
highlighted.  For the most part, no additional discussion is needed.

MPE/iX 5.0 Documentation