HP 3000 Manuals HP 3000 Manuals
DICTDBA MESSAGES Errors --------------------------------------------------------------------------------------------- | | | | MESSAGE | EXPLANATION AND/OR ACTION | | | | --------------------------------------------------------------------------------------------- | | | | *ERROR: BASE NAME TOO LONG | Data base name, including qualifiers, is | | | greater than 24 characters. | | | | | *ERROR: DATA BASE OPERATION: | A data base error occurred when reading | | | information. An IMAGE "DBEXPLAIN message | | | block" is issued to explain the error | | | condition. | | | | | *ERROR: INVALID MODE | Response to MODE prompt is a number other | | | than 1 through 8. | | | | | *ERROR: INVALID RUN MODE | An incorrect response to RUN MODE prompt | | | entered. | | | | | *ERROR: LIST FILE OPERATION | An error occurred during writing the list | | | file (DICTLIST). | | | | | *ERROR: PASSWORD LONGER THAN 8 CHARACTERS | Response to BASE PASSWORD prompt is greater | | | than 8 characters. | | | | | *ERROR: LIST FILE OPEN | Device LP is not available. Use a file | | | equation to redirect DICTLIST. | | | | --------------------------------------------------------------------------------------------- Warnings --------------------------------------------------------------------------------------------- | | | | MESSAGE | EXPLANATION AND/OR ACTION | | | | --------------------------------------------------------------------------------------------- | | | | *WARNING: BROKEN CHAIN(S): | A broken chain has been encountered in a | | | detail set. The data base should be | | | unloaded serially with DICTDBU and then | | | reloaded with DICTDBL to recover the data | | | base. | | | | | *WARNING: CONTROL(Y) NOT ENABLED | Attempt to enable Control Y failed. | | | | | *WARNING: HIGH MASTER SET OCCUPANCY | The occupancy of a master set is higher | | | than 80%. Consider increasing the data set | | | capacity to reduce the occurrence of | | | synonym chains (unless the capacity is only | | | one entry). | | | | | *WARNING: SERIAL COUNT ERROR | Physical serial read count of a master set | | | does not equal the IMAGE table count. The | | | data base should be unloaded serially with | | | DICTDBU and then reloaded with DICTDBL to | | | recover the data base. | | | | ---------------------------------------------------------------------------------------------