HP 3000 Manuals

DICTIONARY 3000

HELP 

Displays a description of the DICTPDE commands and subcommands.

Syntax 

     HELP subcommand 
     H
     ?

Use the HELP command to display information about each of the DICTPDE
commands and their respective subcommands.  Note that you can also enter
"?" to invoke this command.  The HELP command uses all the DICTPDE
commands as its subcommands.  The DICTPDE command (used as a subcommand)
identifies the command for which a description will be displayed, as
shown below:

Subcommands 

The following subcommands can be used with the HELP command:

ALTER            defines the ALTER command and its subcommands.
A

EXIT             defines the EXIT command and alternate ways to
E                terminate DICTPDE.

GENERATE         defines the GENERATE command and its subcommands.
G

HELP             defines each of the DICTPDE commands.
H

LIST             defines the LIST command and its subcommands.
L

Note that the HELP command can not be used when DICTPDE is run from a job
stream.

MPE/iX 5.0 Documentation