HP 3000 Manuals

Netware 3.11 for the HP 3000 Installing and Administering Guide

Transport Parameters 

2.  Configuration

1.  Transport Configuration

1.  Transport Parameters


          Figure 10-4.  Transport Parameters 

Internal Network Number 

This parameter specifies the unique network number for the internal
network.  Enter a string representing a hexadecimal number in the range
of 0x0-0xF, non-inclusive (00000001-FFFFFFFE). Network addresses are used
by the NetWare operating system to set apart networks (cabling systems).
The internal network number can also be configured using Quick
Configuration, Quick Config Parameters screen.

SAP Flag 

This flag specifies whether the architecture daemon (npsd) should
activate the service advertising protocol (SAP) when npsd starts.  SAP
queries are packets that ask about specific server types on the network.
The choices are ACTIVE and INACTIVE. If the SAP flag is set to INACTIVE,
no services, printing, or logins are available.

SAP GNS Reply Delay 

This parameter specifies the amount of time the sapd requires before
responding to a Get Nearest Server (GNS) request.  The sapd is the daemon
that captures all SAP traffic and responds to SAP queries.  This
parameter allows the user to offload some of the work from the NetWare
server.

SAP Standard Output 

This parameter specifies the device or file that all standard output
messages are sent to, including tracking messages.  This should usually
be the console device.

SAP Error File/Device 

This parameter specifies the device or file that all standard error
messages are sent to.  This should be a file.

MPE/iX 5.5 Documentation