HP 3000 Manuals

Introduction to MPE XL for MPE V System Administrators

Obtaining Information About Spoolfiles--the LISTSPF command 

Use the LISTSPF command to obtain information about input and output
spoolfiles.


NOTE  The SPOOLID's provided in these examples are for illustrative
      purposes only.  You would use actual SPOOLID's from your
      environment.


Information by SPOOLID 

To obtain information by SPOOLID for specific output spoolfiles, you
would enter:

     LISTSPF 357 

or, for more than one spoolfile:

     LISTSPF (357,375,458) 

Information for All SPOOLIDS 

To obtain information about all spoolfiles enter:

     LISTSPF @ 

or, because the default is all spoolfiles enter:

     LISTSPF 

To obtain information about all output spoolfiles:

     LISTSPF O@ 

To obtain information about input spoolfiles only enter:

     LISTSPF I@ 

To obtain information about all users in a given account (in this example
the MFG account) enter:

     LISTSPF;SELEQ=[OWNER=@.MFG] 


NOTE  In this form of the LISTSPF command you must use brackets as shown,
      not parentheses.

[REV END]

[REV
BEG]

MPE/iX 5.0 Documentation