HP 3000 Manuals HP 3000 Manuals
Replying to a Media Request
Check that the request comes from the user who gave you the media.
First, locate the user's job or session number in the media request.
There can be different PINs for each request. In the following example,
the session number is #S37.
?16:04/#S37/23/LDEV# FOR "T" ON MEDIA (NUM)?
Issue a SHOWJOB command to determine from which user the request came.
For example:
:SHOWJOB #S37
The system describes the job or session. For example:
____________________________________________________________________
| |
| |
| JOBNUM STATE INPRI JIN JLIST INTRODUCED JOB NAME |
| #S37 EXEC 36 36 MON8:46A |
| WANDA.PERSONEL |
| |
| JOBFENCE= 5; JLIMIT= 10; SLIMIT= 40 |
| |
____________________________________________________________________
Figure 7-1. Job Session Description
Check that the job name matches the user's job name. If it does, use the
REPLY command to assign the backup device to the user.
To reply to a media request, you need to know the STORE or RESTORE user's
PIN and the media drive's LDEV number. For example, the PIN for the
following media request is 23.
?16:04/#S37/23/LDEV# FOR "T" ON MEDIA (NUM)?
The backup device's LDEV number appears in the message you receive when
you mount a media on the backup device. In the following message, the
LDEV number is 8.
16:05/31/VOL (Unlabeled) mounted on LDEV#8
To answer a media request, use the REPLY command to assign the LDEV
number to the PIN. For example, the following REPLY command assigns LDEV
8 to PIN 23.
:REPLY 23,8