HP 3000 Manuals HP 3000 Manuals
Displaying Contents
To display the contents of the Local Data Area (LDAFILE), the RPGUDATE
file, and the user switch settings (U1 through U8), run RPGINIT with the
SHOW entry point, as shown below:
RUN RPGINIT.PUB.SYS,SHOW [;PARM=n]
By running RPGINIT with the SHOW entry point, the current contents of the
LDA file are displayed on the terminal. The character data is blocked in
groups of ten characters for easy verification of correct updating of the
LDA file by programs and by other job control procedures (such as
PROCMON/3000). This screen is shown below:
HP32104A.07.00 RPG INITIALIZER UTILITY (RPGINIT) (C) HEWLETT-PACKARD CO. 1986
RPGUDATE: 090186
USWITCH: U1=OFF, U2= ON, U3=OFF, U4=OFF, U5=OFF, U6=OFF, U7=OFF, U8=OFF
LDAFILE:
0001: AA2001 AS SEM. BRACK ET 22
0051:
0101:
0151:
0201:
0251:
MORE (Y/N)?
0257:
0307:
0357:
0407:
0457:
0507:
If a value for PARM is not specified or is less than 1, you are prompted
to view one 256-byte LDA record at a time. If the value for PARM is
greater than 1, the number specified, or the total number of records in
LDAFILE (whichever is smaller) is displayed without any prompting.
To reinitialize the LDA file to blanks and the RPG user date file to the
system date, rerun RPGINIT with the same PARM value of 1 through 32.