HP 3000 Manuals HP 3000 Manuals
Running RISE
To run RISE you enter the following MPE command at your terminal:
RUN RISE.PUB.SYS
Your command will be answered with an HP banner like the one below:
HP32104A.05.00 RPG INTERACTIVE SYSTEM ENVIROHMENT RISE
(C) HEWLETT-PACKARD CO. 1981 WED, SEP 16, 1981, 10:29 AM
>
With that you have begun the program and entered the RPG Interactive
System Environment. Other MPE commands are available for your use within
the system. A list of these commands may be obtained by typing "HELP:".
The commands are displayed on the screen in Block Mode.
To leave the system you use the EXIT command.
Because of the visual and interactive emphasis in the design of RISE, it
is not recommended that you use it in batch mode.