HP 3000 Manuals

Silhouette Reference Manual

>KILL 

The >KILL command terminates Silhouette processing.

SYNTAX 

     >KILL [configfile]

PARAMETERS 

configfile          The name of the configuration file to be terminated.

DISCUSSION 

The >KILL command terminates processing on the specified configuration
file.  If no configuration file is specified, the current configuration
file is terminated.  When a >KILL command is issued, Silhouette
terminates the duplication process immediately without transferring any
queued transactions from the primary system to the secondary system(s).
The database on the secondary system, therefore, may contain some
incomplete transactions.

EXAMPLE 

The following example shows terminating Silhouette processing on the
specified configuration file.

     >SYSTEM configfile
     This Silhouette system is currently active.  (MPWARN 51)
     >KILL
     Terminate remote : Successful execution of function / request.  (RQMSG 0)

ADDITIONAL DISCUSSION 

See Chapter 3.

MPE/iX 5.0 Documentation