HP 3000 Manuals HP 3000 Manuals
RELOAD
Causes NRJE to reload the Formid Lookup Table.
Syntax
_____________________________________________________________________________
| |
| RELO[AD][;W[SID]=Wsid] |
_____________________________________________________________________________
Parameter
Wsid The workstation name. This can be up to eight alphanumeric
characters long; the first character must be alphabetic.
If you omit this parameter, the default workstation identifier
is used. You can specify a default workstation identifier in
the NRJE command.
Description
This command causes NRJE to reload the Formid Lookup Table into its
internal copy of the table. The RELOAD command can be used any time NRJE
is active. This command should be used anytime the table is modified
after NRJE is started. A message indicating whether the reload attempt
was successful is logged; the message is not necessarily sent to the
terminal of the user who issued the RELOAD command.
This command is not valid unless the workstation is configured to use the
Formid Lookup Table, in the NRJE Configuration: Workstation Data Page 2
screen. Use of the Formid Lookup Table is described in the SNA NRJE
User/Programmer Reference Manual.
Text Reference
See VERIFY later in this chapter for information about verifying the
Formid Lookup Table.