HP 3000 Manuals HP 3000 Manuals
HP 3000 Hardware and Software Requirements
Hardware Requirements
The HP 3000 hardware requirements for SNA NRJE are as follows:
* An HP 3000 Series 37, 39, 4x, 5x, 6x, or 7x that supports an HP
30020A/B/C Intelligent Network Processor (for NRJE/V).
* A HP 3000 900 Series that supports an HP30263A Programmable Serial
Interface (for NRJE/XL).
* Communications line, leased or switched.
* These modems are supported:
HP 37230A up to 9600 bps
Bell 201C 2400 bps
Bell 208A/B 4800 bps
Bell 209A 9600 bps
Bell 2024A 2400 bps
See the Data Communications Handbook, Fundamental Chapter for
communications configurations and strapping options.
* A block mode terminal in addition to the system console for Node
Management Services configuration. This terminal must be supported
by VPLUS . See the SNA Link Services Reference Manual or the SNA
Link/XL Node Manager's Guide.
Software Requirements
HP 3000 software requirements to run SNA NRJE are as follows:
* MPE V Operating System: HP 32033G (for NRJE/V).
* MPE XL Operating System (for NRJE/XL).
* SNA Link/V : HP 30246A (for NRJE/V). This enables SNA NRJE to
communicate with the host job entry subsystems in the SNA
environment.
or
* SNA/SDLC Link/XL: HP 30291 (for NRJE/XL).
or
* SNA/X.25 Link/XL: HP 30298 (for NRJE/XL).