HP 3000 Manuals HP 3000 Manuals
Chapter 6 MPE Commands
This chapter describes, in alphabetical order, the MPE commands related
to SNA Transport. You must have MPE node manager (NM) capability to use
these commands. Table 6-1 summarizes the functions of the commands.
Table 6-1. MPE Command Summary
-------------------------------------------------------------------------
| | |
| Command | Function |
| | |
-------------------------------------------------------------------------
| | |
| RESUMENMLOG | Resumes NM logging after a recoverable |
| | error. |
| | |
| SHOWNMLOG | Displays the identification number and |
| | available space of the NM log file. |
| | |
| SNACONTROL AUTODIAL | Causes an SNA node's auto-dial modem to |
| | dial. |
| | |
| SNACONTROL START | Starts an SNA node, link-level tracing, |
| | and SNA Transport node tracing. |
| | |
| SNACONTROL STATUS | Displays the status of a specific SNA |
| | node. |
| | |
| SNACONTROL STOP | Stops an SNA node and all activity on the |
| | node. |
| | |
| SNACONTROL STOPSESS | Stops an LU-LU session without stopping |
| | the SNA node. |
| | |
| SNACONTROL TRACEOFF | Turns off link-level tracing, SNA |
| | Transport intrinsic tracing, and SNA |
| | Transport node tracing. |
| | |
| SNACONTROL TRACEON | Turns on link-level tracing, SNA Transport |
| | intrinsic tracing, and SNA Transport node |
| | tracing. |
| | |
| SNACONTROL VERSION | Identifies the software version of SNA |
| | Transport, SNA/X.25 Link, and SNA/Token |
| | Ring Link. |
| | |
| SWITCHNMLOG | Closes the current NM log file and creates |
| | and opens a new one. |
| | |
-------------------------------------------------------------------------