HP 3000 Manuals

MPE Segmenter Reference Manual

COMMANDS 

The command specifications contain the following information:

 *  The command name.

 *  The type of command (Segmenter or MPE command).  This information is
    shown in italics directly under the command name.

 *  A brief summary of the command's function.

 *  Syntax.  The command syntax is highlighted by enclosure in a box.

 *  Parameter definitions, including meaning, constraints, and defaults.

 *  Examples.

 *  Text discussion.  (The page in this manual where usage of the command
    is discussed.)

For more information about MPE commands, see the MPE V Commands Reference 
Manual (32033-90006).  Segmenter commands consist of the following
elements:

 *  The command name.  In an interactive session, the Segmenter displays
    a dash (-) as a prompt when it is ready to accept a command.  Note
    that the prompt character is not allowed when entering Segmenter
    commands in a batch job.  The command name is shown in this section
    with a preceding prompt character.

 *  Parameters, if any, follow the command name.  A blank character must
    be used between the end of the command name and the first parameter.

MPE/iX 5.0 Documentation